Справочник Пользователя для Q-Logic 8200 SERIES

SN0054628-00  A

6-1

Troubleshooting

This section provides resolutions for issues that you may experience during system 
start-up and configuration of the SANbox SSP. 

The recommended actions in this section assume that you are 
troubleshooting components of the SANbox SSP, and that the platform 
is in the original factory configuration. If you have removed or replaced 
components or changed any default settings or driver firmware, the 
recommendations in this section may not apply.

This section discusses:

■

■

 

Before looking through the list of problem statements:

■

Confirm that the SANbox SSP is powered on and that the Alert LED is green.

■

Configure the IP address for the management port: from the command line 
interface (CLI), run the Modify eth command. See 

 for more information about this command.

■

Confirm that all connected ports are fully seated and the link LED is illuminated.

■

Confirm that all the other components of the system (fabric switches, storage 
arrays, and so on) are powered up and properly configured.

Before contacting technical support, see 

 for more 

information, including how to run Show Debug Dump and how to create a trace file.