Справочник Пользователя для Jasco HO98058

Please keep this user’s manual in a safe place. Every time the 
batteries in the keyboard and mouse are changed, you will need 
to re-link them. To do so, you will need to follow steps 5 – 11. 
 
1.  Uninstall any existing keyboard or mouse software from 

your computer by going to “Add/Remove Programs” in the 
“Control Panel”. 

2.  Shut down and turn off your computer before connecting or disconnecting any PS/2 device (failure to 

do so could damage your computer). 

 
3.  Disconnect existing keyboard and mouse from your computer. 
 
4.  Plug the two PS/2 plugs on your new receiver into the correct ports on your PC.  (Make sure the green 

mouse plug is plugged into the mouse port, and the purple keyboard plug is plugged into the keyboard 
port) 

5.  Install the included batteries into the battery compartments located on the bottom of your keyboard and 

mouse. Make sure the polarity corresponds to the symbols in the battery compartment. 

6.  Place the receiver 8” (20cm) from any other electronic device such as computer, monitor, to ensure no 

interference. 

7.  Place the keyboard and mouse within 3ft. (approximately 1 meter) of the receiver for optimal 

communication. 

8.  Turn on your computer and start your Operating System. 

9.  Press the Link button on your receiver. The light should 

begin to blink. 

 
 

Page - 5 -