Справочник Пользователя для ViPowER VP-6020
4
CD-ROM Box Enclosure Installation Guide
a. Attach the IDE 40-pin data cable from the end-panel to the 40-pin connector
on the back of the CD-ROM drive. To ensure pin-1 to pin-1 connection,
orient the cable so the colored stripe edge is closest to the power connector.
orient the cable so the colored stripe edge is closest to the power connector.
b. Attach the 4-pin power cable from the end-panel to the 4-pin connector on the
back of the CD-ROM drive. The connector is ‘D’ shaped to ensure proper
connection.
connection.
2. Place the CD-ROM drive in the bottom enclosure cover. The CD-ROM drive’s
front face panel should be flush with the front corners of the case (positioned in
front of the guide flanges.)
front of the guide flanges.)
3. Align the CD-ROM drive’s mounting holes with the mounting holes on the drive
rails and secure with four screws (two on each side).
4. Slide the back-panel connector assembly back into the end groove guide.
5. Place the top cover over the drive assembly, making sure the end-panel assembly
slides into its end groove guide.
Installing Covers and Rubber Stands
Top Cover
Bottom
Cover
Cover
Drive
Mounting
Screws (x4)
Mounting
Screws (x4)
CD-ROM
Drive
Drive
Rubber
Stands (x4)
Stands (x4)
End-Panel
Assembly
Assembly
Top Cover
Mounting
Screws (x4)
Mounting
Screws (x4)