Справочник Пользователя для Bosch DVA-08K

en | Subsystem Maintenance

RAID Subsystem DVA-08K | Installation Manual

F.01U.027.797 | V2 | 2008.08

Bosch Security Systems

The screw is located below the extraction lever, beside the LED indicator, and can be hid-

den from sight.

PSU Parts Identification

4.

Pull the extraction handle downward: Push the extraction lever at the back of the PSU 

module downwards. This will dislodge the PSU module from the subsystem. Once dis-

lodged, gently pull the PSU module out of the subsystem.

5.

Remove the cooling module: To do this, push the clips on either side of the module rear 

panel together. Then gently pull the cooling module out of the lower level of the PSU 

bracket. (See Figure 6.5)

Remove the Cooling Module

6.

Reinstall the cooling module into the new PSU module: To do this, align the cooling mod-

ule with the lower level of the PSU bracket and gently slide the cooling module in. 

•

When a PSU is pulled out of the chassis, the fan module beneath the PSU is removed 

from the chassis at the same time.

•

Do not remove the PSU module unless a replacement is readily available. Removing a PSU 

without a replacement will cause severe disruptions to the internal airflow and the sub-

system will overheat, possibly causing irreparable damage to some of the subsystem 

components.

•

It is recommended that the replacement procedure is completed in less than five (5) min-

utes to prevent the subsystem from overheating.