Справочник Пользователя для Intel PCM-9387

The procedures for installing SODIMMs are described below. Please fol-
low these steps carefully. You can install SDRAM memory modules 
using 200-pin SODIMMs (Small Outline Dual In-line Memory Modules).

1.

Ensure that all power supplies to the system are switched off.

2.

Tilt the SODIMM card approximately 25

o

 above the board, and 

move it in the direction of the housing card slot. Make sure that the key in 
the module and the key in the housing are aligned.
3.

Push the module into the socket until the module bottoms. There 

should be a slight insertion force to engage the module into the contacts.

The board provides 1 IDE channels which you can attach up to two 
Enhanced Integrated Device Electronics hard disk drives or CDROM to 
the board’s internal controller. Its IDE controller uses a PCI  interface. 
This advanced IDE controller supports faster data transfer, PIO mode 3, 
mode 4 and up to UDMA/33.  

Module Key Aligned
With housing Key

Module Tilted
Approximately 25

1

2

3

Module Latching
Ledge(TO Engage
Edge of Module)

Housing
Card Slot

PC Board