Справочник Пользователя для Intel US15W

 

User’s Manual 

 36 

    Document Number: 320264 

To enable the port for Mini Card B (J2G1), PCI Express* Slot 0 (J7C1) and USB Port 0 
(J2A1) devices must be redirected to the Mini Card B connector. 

Enable Mini Card B 

Remove – R2B2, R2B4  
Populate – R2B3, R2B5, R8Y7, 

R8W19, R8Y2, R8Y1, 
R8W22 

Rework provides proper USB and SIM card 
connectivity for wireless WAN cards from 
Sierra Wireless* and Option* only. However, 
there are a significant number of additional 
no-stuff components that must be populated 
for full functionality. Refer to the Mini Card B 
sheet of the Crown Beach Schematics for 
details. 
USB Port 0 functionality through connector 
J2A1 is disabled when Mini Card B is enabled. 

The microcontroller firmware for system management/keyboard/mouse control can be 

upgraded in two ways:  
1.  By use of a special MS-DOS utility (in-circuit).  
2.  By use of an external computer connected (remotely) to the system through the 

serial port on the board. 

If the user chooses in-system programming of the Crown Beach board, ensure that 
the following files are available on the DOS bootable media: 
1.  EC_xx.bin 

  - 

EC 

application 

2.  Fcntl.bin 

 

 

- Renesas Technology* flash algorithm data file 

3.  Kscflash.exe   - 

downloader 

Boot to a DOS environment on the Crown Beach machine and type “kscflash 
ec_xx.bin” to begin programming the EC. 

If the user chooses to use an external computer (remote programming) connected to 

the system through the serial port, there are three jumpers that must be set correctly. 

Refer to 

Table 9

 for a summary of these jumpers and refer to the Crown Beach 

schematic for the location of each jumper. 

The sequence of events necessary to program the H8 is as follows: