Справочник Пользователя для Intel D975XBX

24   

 

 

When you install and test the Intel desktop board, observe all warnings and cautions in the 
installation instructions. 
To avoid injury, be careful of: 
•  Sharp pins on connectors 
•  Sharp pins on printed circuit assemblies 
•  Rough edges and sharp corners on the chassis 
•  Hot components (like processors, voltage regulators, and heat sinks) 
•  Damage to wires that could cause a short circuit 
Observe all warnings and cautions that instruct you to refer computer servicing to qualified 
technical personnel. 

Do not overload the power supply output.  To avoid overloading the power supply, make sure that 
the calculated total current loads of all the modules within the computer is less than the output 
current rating of each of the power supplies output circuits.   

Read and adhere the instructions in this section and the instructions supplied with the chassis and 
associated modules.  If you do not follow these instructions and the instructions provided by the 
chassis and module suppliers, you increase safety risk and the possibility of noncompliance with 
regional laws and regulations.  If the instructions for the chassis are inconsistent with these 
instructions or the instructions for associated modules, contact the supplier’s technical support to 
find out how you can ensure that your computer meets safety and regulatory requirements.   

For information about regulatory compliance, go to Appendix B on page 69.