Справочник Пользователя для Intel DQ35MP
Installing and Replacing Desktop Board Components
55
Connecting to the USB 2.0 Headers
Before connecting to the USB 2.0 headers, observe the precautions in "Before You
Begin" on page 31. See Figure 23, G on page 51 for the location of the three USB 2.0
headers. Table 11 shows the pin assignments for each USB 2.0 header. Each USB
header can be used to connect two USB devices.
Begin" on page 31. See Figure 23, G on page 51 for the location of the three USB 2.0
headers. Table 11 shows the pin assignments for each USB 2.0 header. Each USB
header can be used to connect two USB devices.
Table 11. USB 2.0 Header Signal Names
USB Port A
USB Port B
Pin
Signal Name
Pin
Signal Name
1
Power (+5 V)
2
Power (+5 V)
3 D-
4 D-
5 D+
6 D+
7 Ground
8 Ground
9 Key
10
No
Connection
Note: USB ports may be assigned as needed.
NOTE
Computer systems that have an unshielded cable attached to a USB port might not
meet FCC Class B requirements, even if no device or a low-speed USB device is
attached to the cable. Use a shielded cable that meets the requirements for a
full-speed USB device.
meet FCC Class B requirements, even if no device or a low-speed USB device is
attached to the cable. Use a shielded cable that meets the requirements for a
full-speed USB device.
Connecting to the Audio System
After installing the RealTek audio driver from the Intel Express Installer DVD-ROM, the
multi-channel audio feature can be enabled. Figure 24 shows the back panel audio
connectors. The default connector assignments are shown in the table.
multi-channel audio feature can be enabled. Figure 24 shows the back panel audio
connectors. The default connector assignments are shown in the table.
Item Description
A Audio
A Audio
line
in
B
Audio line out
C Mic
in
Figure 24. Back Panel Audio Connectors