Справочник Пользователя для Intel DQ35MP

60 

This section describes how to clear or change the following passwords: 
•  BIOS security passwords (user and supervisor)  
•  Hard disk drive passwords (User and Master) 

This procedure assumes that the board is installed in the computer and the 
configuration jumper block is set to normal mode. 
1.  Observe the precautions in "Before You Begin" on page 31. 
2.  Turn off all peripheral devices connected to the computer.  Turn off the computer.  

Disconnect the computer’s power cord from the AC power source (wall outlet or 
power adapter). 

3.  Remove the computer cover. 
4.  Find the configuration jumper block (see Figure 27). 
5.  Place the jumper on pins 2-3 as shown below. 

 

6.  Replace the cover, plug in the computer, turn on the computer, and allow it to 

boot. 

7.  The computer starts the Setup program.  Setup displays the Maintenance menu.   
8.  Use the arrow keys to select Clear Passwords.  Press <Enter> and Setup displays a 

pop-up screen requesting that you confirm clearing the password.  Select Yes and 
press <Enter>.  Setup displays the maintenance menu again. 

9.  Press <F10> to save the current values and exit Setup. 
10. Turn off the computer.  Disconnect the computer’s power cord from the AC power 

source. 

11. Remove the computer cover. 
12. To restore normal operation, place the jumper on pins 1-2 as shown below. 

 

13. Replace the cover, plug in the computer, and turn on the computer.