Справочник Пользователя для Intel E7501

INSTALLATIONS

AFW-3000 User’s Manual

ATX Power Installation

The system power is provided to the AFW-3000 Server Motherboard
with the CN7 and CN8 ATX power connectors. CN8 is a 4-pin power
connector. CN7 is a 20-pin ATX power connector.

Installing the Memory

The AFW-3000 Server Motherboard supports two DDR memory sockets
for a maximum total memory of 4GB in DDR memory type.

Note: DIMM modules must be DDR/ECC/Reg Only.

Modules “in pairs” must be the same type and size.

The memory module capacities supported are 64MB, 128MB, 256MB,
512MB, 1GB and 2GB. The following table lists the supported DDR
DIMM configurations.

Supported DDR DIMM Configurations.

Density

64 Mbit

128Mbit

256Mbit

512Mbit

Device
Width

Single/
Double

SS/DS

184-pin
DDR

128/256MB 64/128MB 256/512MB 128/256MB 512MB

/1GB

256/512MB 1GB/2GB

512MB

/1GB

Installing and Removing Memory Modules

To install the DDR modules, locate the memory slot on the Server
Motherboard and perform the following steps:

1. Hold the DDR module so that the keys of the DDR module align with

those on the memory slot.

2. Gently push the DDR module in an upright position until the clips of

the slot close to hold the DDR module in place when the DDR module
touches the bottom of the slot.