Справочник Пользователя для Intel GME965

316704-001 / Development Kit User’s Manual   

 47 

VID 0 

CR1B1 

VID 1 

CR1B2 

VID 2 

CR1B3 

VID 3 

CR1B4 

VID 4 

CR1B5 

VID 5 

CR1B6 

VID 6 

CR1B7 

M0/M1 CR4H1 

System Power Good 

CR5J1 

Reserved CR8G1 

The microcontroller firmware for system management/keyboard/mouse control can be 

upgraded in two ways.  The user can either use a special DOS* utility known as 

KSCFlash (in-circuit) or use an external computer connected (remote) to the system 

via the serial port on the development board. KSCFlash is available on request from 

your Intel representative. 

If the user chooses to use an external computer connected to the system via the serial 

port, there are four jumpers that must be set correctly first.  Please refer to 

Table 15

 

for a summary of these jumpers and refer to 

Figure 7

 for the location of each jumper. 

Required Hardware: one Null Modem Cable and a Host Unit with a serial COM port 

(System used to flash the development board) 

Here is the sequence of events necessary to program the H8 via the serial port. 

1.  Extract all files (keep them in the same folder) to a single directory of your 

choice on the host machine or on a floppy disk. 

2.  Connect a NULL modem cable to the serial ports of each platform (host and 

unit to be flashed). 

3.  With the development board powered off, move the following jumpers to the 

programming stuffing option. 

a.  J9G2 (remove) (default: 1-2), Sets SMC_INIT_CLK high. 

b.  J8B1 (2-3) (default: 1-2), link the Host Unit to on-board H8. 

c.  J8B2 (2-3) (default: 1-2), link the Host Unit to on-board H8.