Справочник Пользователя для IBM 81Y
64
Hardware Maintenance Manual: xSeries 250
Installing a non-hot-plug PCI adapter (slots 1 and 2)
The following illustration shows how to install a non-hot-plug PCI adapter.
Note:
The illustrations in this document might differ slightly from your hardware.
Before you begin:
•
•
Review the information in “Before you begin” on page 58.
To install a non-hot-plug PCI adapter:
Attention:
When you handle static-sensitive devices, take precautions to avoid
damage from static electricity.
1.
Turn off the server; then, disconnect the power cords.
2.
Remove the top cover (see “Removing the top cover” on page 59).
3.
Determine which expansion slot you will use for the adapter.
Note:
PCI slots 1 and 2 support non-hot-plug PCI adapters only.
4.
Remove the expansion-slot cover:
a.
Rotate the adapter retention latch counterclockwise.
b.
Lift the tab covering the top of the expansion-slot cover and then remove the
expansion-slot cover from the server. Store it in a safe place for future use.
expansion-slot cover from the server. Store it in a safe place for future use.
c.
Press on the rear adapter retention latch (near the hard disk drives) as
indicated by the arrow on the latch and lift it to the open position.
indicated by the arrow on the latch and lift it to the open position.
Attention:
You must install expansion-slot covers on all empty slots. This
maintains the electromagnetic emissions characteristics of the system and
ensures proper cooling of system components.
ensures proper cooling of system components.
Adapter retention latch
Tab
Adapter
retention latch
retention latch
Adapter