Справочник Пользователя для Intel 281809-003

••

−−

Errors can occur during POST (Power On Self Test) which is performed every time the system is powered on.  Fatal
errors, which prevent the system from continuing the boot process, are communicated through a series of audible
beeps.  Other errors are displayed in the following format:

ERROR Message Line 1

ERROR Message Line 2

For most displayed error messages, there is only one message. If a second message appears, it is "RUN SETUP". If
this message occurs, press <F1> to run AMIBIOS Setup.

1

Refresh Failure

The memory refresh circuitry on the motherboard is faulty.

2

Parity Error

Parity is not supported on this product, will not occur.

3

Base 64 KB Memory Failure

Memory failure in the first 64 KB.

4

Timer Not Operational

Memory failure in the first 64 KB of memory, or Timer 1 on the motherboard is not

functioning.

5

Processor Error

The CPU on the motherboard generated an error.

6

8042 - Gate A20 Failure

The keyboard controller (8042) may be bad. The BIOS cannot switch to protected

mode.

7

Processor Exception Interrupt Error

The CPU generated an exception interrupt.

8

Display Memory Read/Write Error

The system video adapter is either missing or its memory is faulty. This is not a fatal

error.

9

ROM Checksum Error

ROM checksum value does not match the value encoded in BIOS.

10

CMOS Shutdown Register Rd/Wrt Error

The shutdown register for CMOS RAM failed.

1 LONG

3 SHORT

VIDEO ERROR

Video Controller failure

8042 Gate - A20 Error

Gate A20 on the keyboard controller (8042) is not working. Replace the 8042.

Address Line Short!

Error in the address decoding circuitry on the motherboard.

Cache Memory Bad, Do Not Enable Cache!

Cache memory is defective. Replace it.

CH-2 Timer Error

Most AT systems include two timers. There is an error in timer 2.

CMOS Battery State Low

CMOS RAM is powered by a battery. The battery power is low. Replace the battery.

CMOS Checksum Failure

After CMOS RAM values are saved, a checksum value is generated for error checking. The

previous value is different from the current value. Run AMIBIOS Setup.

CMOS System Options Not Set

The values stored in CMOS RAM are either corrupt or nonexistent. Run Setup.

CMOS Display Type Mismatch

The video type in CMOS RAM does not match the type detected by the BIOS. Run AMIBIOS

Setup.

CMOS Memory Size Mismatch

The amount of memory on the motherboard is different than the amount in CMOS RAM. Run

AMIBIOS Setup.