Справочник Пользователя для Promise Technology M310p
VTrak M310p, M210p Product Manual
178
Replace RAID Controller
The RAID Controller monitors and manages the logical drives. When this
controller is replaced, all of your logical drive data and configurations remain
intact because this logical drive information is stored on the disk drives.
controller is replaced, all of your logical drive data and configurations remain
intact because this logical drive information is stored on the disk drives.
To remove and replace the RAID Controller:
1.
Power down the VTrak.
2.
Remove the network, SCSI, and null modem cables.
3.
Grasp the handle and pull it downward (above, left).
4.
Grasp the Controller and pull it out of the enclosure.
5.
Gently slide the new Controller into the enclosure.
6.
Press on the front to seat the Controller. The handle will swing upward as the
Controller is properly seated (above, right).
Controller is properly seated (above, right).
7.
Attach the network, SCSI, and null modem cables.
8.
Power up the VTrak.
This completes the RAID Controller replacement procedure.
Caution
The RAID Controller is NOT a hot-swappable device. Power-down
the VTrak before removing it.
the VTrak before removing it.
Important
Do not replace the RAID Controller based on LED colors alone.
Only replace the RAID Controller when directed to do so by
Promise Technical Support. See page 239.
Only replace the RAID Controller when directed to do so by
Promise Technical Support. See page 239.