Справочник Пользователя для Lucent Technologies R5SI
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-170
BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)
10
BRI Port Local TDM Loop Around Test (#619)
This test is destructive
.
This test verifies the connectivity of a BRI port across the TDM Bus. It aborts if
calls associated with the port are in progress. Failure of this test indicates an
on-board fault associated with the port hardware on the circuit pack.
calls associated with the port are in progress. Failure of this test indicates an
on-board fault associated with the port hardware on the circuit pack.
This Loop Around Test runs a series of individual tests on the two B-channels (B1
and B2) associated with the port. It is a collection of the following:
and B2) associated with the port. It is a collection of the following:
1144
ABORT
The PPN Packet Bus is out-of-service.
1. Follow the repair procedures for the Packet Bus.
2. After completing Step 1, execute the
test port long
PCSSpp
command, and review the results of the
BRI Port Local LAN Loop Around Test to verify the
repair.
repair.
2012
ABORT
Internal System Error.
2100
ABORT
Could not allocate the necessary system resources to
run this test.
run this test.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
FAIL
The Loop Around Test has failed.
1. If the test fails repeatedly, attempt to reset the circuit
pack if the other ports on the board are not in use.
Reset the circuit pack by issuing the
Reset the circuit pack by issuing the
busyout board
PCSS
and the
reset board PCSS
commands.
2. If the test fails again, execute
test pkt P
on the
G3MT terminal. If this fails, follow failure procedures
in PKT-BUS section.
in PKT-BUS section.
3. If tests executed in Step 2 pass, the problem is local
to the BRI board. Replace the circuit pack.
PASS
The BRI Port Local LAN Loop Around Test has passed.
Table 10-55.
TEST #618 BRI Port Local LAN Loop Around —
Continued
Error
Code
Test
Result
Description/ Recommendation
Continued on next page