Справочник Пользователя для Lucent Technologies R5SI
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1368
TAPE (Tape Unit) [G3iV1.1-286]
10
Aux Data Values Indicating the Tape File Type
This table translates Aux Data values to the corresponding tape file type.
Tape Drive Head Cleaning Procedure
The tape drive head (also called the tape head) should be cleaned at least once
a year.
a year.
However, as part of the preventive maintenance strategy, it is
recommended that you inspect the tape head during each maintenance visit
and that you clean the tape head several times a year
and that you clean the tape head several times a year
. In addition, a dated
label should be placed on the tape drive unit after the tape head is cleaned. You
should also complete the "AT&T Preventive Maintenance Log" sheet. (Refer to
should also complete the "AT&T Preventive Maintenance Log" sheet. (Refer to
New tapes leave more abrasive particles on the tape head. Therefore, if a new
tape is used, issue the
tape is used, issue the
test tape long repeat 3
command, and then clean the
tape head.
The tape head can be accessed for cleaning from the front of the drive by
opening the tape access door with your finger. See
opening the tape access door with your finger. See
Table 10-417.
Table C. Tape File Types
Aux Data Value
File Type
0
Primary Translation File
1
Backup Translation File
2
Core Dump File
3
Program Update File
4
Boot Image File
6
Error Log File (not including scratch area)
12
Stored Announcement File
16
Processor Interface Firmware File
17
Header Block
19
Packet Control Firmware File
20
NIPM File
21
X25 File
22
Primary Directory File
23
Backup Directory File