Справочник Пользователя для Lucent Technologies R5SI

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-283

release journal-printer 

 Command resources busy; Press CANCEL to clear, and then 

resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

 All maintenance resources busy; try again later

For the following output example, assume that the command that was entered is 
"release journal-printer wakeup-log."

The maintenance of a particular component on a link will sometimes interfere with 
the maintenance of the link itself. Maintenance can put a link component in a 
busy state causing link set-up to fail. Frequent attempts at re-setup of a link may 
delay the recover of a faulty component, due to the maintenance test of a 
component only taking place when the component is idle. Therefore, the 
technician needs to be able to disable the attempted re-setup of a link. The 
busyout command is used to do this, and will not cause the link to be torn down. 
If the link is already down, the busyout command will stop periodic re-setup 
attempts on the link.

Port

The port address (cabinet-carrier-slot-circuit) of the maintenance 
object that is being busied out or released. In this case, the 
physical object port address will be a 0 for wakeup log and a 1 
for the pms log.

Maintenance Name

The type of maintenance object that is being busied out or 
released.

Alt. Name

Not applicable.

Result

An indicator as to whether the object was successfully busied out 
or released.

Error Code

A numerical description of why the command failed.

 
 release journal-printer wakeup-log

                          COMMAND RESULTS

 Port   Maintenance Name   Alt. Name   Result   Error Code
  0         JRNL-LINK                  PASS

 Command successfully completed