Справочник Пользователя для Addonics Technologies RR2035ASDES

Note: The Port Multiplier will only work with a Port Multiplier aware host. Identify your 

host controller and check with its hardware manufacturer if you are unsure. Addonics 

offers several Port Multiplier capable host adapters. 

When the port multiplier (PM) is connected to a host controller with 

SiI3124 or SiI3132 chip, in the RAID BIOS of the host controller you will only see 

one drive and that is the drive connected to SATA port 1 on the Port Multiplier.

All SATA drives connected to the PM will show in the SATARAID5 Array Manager.

Refer to the SATARAID5 Management Utility User Guide V1.6 for RAID 

implementation

http://www.addonics.com/support/user_guides/host_controller/SATARAID5-UserGuid

e_v1.60.pdf

a. 

Connect the power cord provided from the wall outlet to the back of the rack.

b. 

Make sure the power is off (power LED light should be off).

c. 

Connect the RAID Rack to the computer using the provided eSATA cables.

This power supply provides 500W of 

power. Before turning on the main 

switch located on the front panel of 

the storage rack, turn on the power 

switch of the power supply.

Power Switch

Fan

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)   

Phone: 408-453-6212 

Email: www.addonics.com/support/query/

1. 

Attach the SATA hard drives (up to 5) to the SATA ports on the Hardware  

 

 

Port Multiplier (HPM) using SATA cables. It is recommended to connect  

 

 

drives to the SATA ports 1 to 5 successively.

2. 

To provide power to the HPM, connect a 4-pin floppy power cable from the    

 

system power supply to the floppy power connector on the HPM.

3. 

Optional: Connect LEDs to the Activity & Error LED jumper block

1. 

For Windows users, install the JMicron HW RAID Manager located on the    

 

SATA Controller CD. In the CD, go to Configuration Utilities > JMB393. This    

 

manager can be use to create and monitor the status of the RAID volume.

 

It is recommended to use the default factory RAID DIP switch setting when    

 

using the JMicron HW RAID Manager.

2. 

Modify the RAID mode on the 5-port HPM-XA using DIP switch

 

Recommended to be used on operating system without JMicron HW RAID    

 

Manager support like Linux, Mac & Solaris. Windows users can also use the   

 

procedure below.

 

a. 

Set the DIP switch as shown below. 

 

b. 

Press the RAID setting button with a ball point pen.

 

c. 

While pressing the RAID setting button turn on the system power    

 

 

where the HPM is connected. The buzzer will sound while holding the  

 

 

RAID setting button. Release it after at least 5 seconds for hardware   

 

 

initialization. A single beep will be heard to indicate initialization is    

 

 

completed. The above steps act as a reset.

 

d. 

Power off the system power.