Справочник Пользователя для Addonics Technologies RT93SNDHMS

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)   

Phone: 408-453-6212 

Email: www.addonics.com/support/query/

NOTE: This procedure destroys all RAID data. It should not harm individual 

drives or their contents; however, creating or running backups of all data is 

strongly recommended before proceeding.

1. 

Power down the unit and set the dip switch to the factory default 

setting (all switches OFF).

2. 

While holding the SET button with a ballpoint pen, turn the unit on. A 

long beep will sound from the Port Multiplier. The SET button may be released 

once the long beep stops.

 

1. 

Be sure the lock on each drive doors 

is in an unlock position. If not use the key 

that comes with the Disk Array to unlock the 

drive door. Pull on the door lever to swing 

open the drive door all the way.

2. 

Slide a 3.5” SATA hard drive into the 

drive slot with the drive connector side 

facing in. Be sure to orient the hard drive 

correctly as shown in the yellow label on the 

inside of the drive door – with drive door 

swing open at the bottom, the top of the hard 

drive should face to the right. The drive 

should slide all the way into the slot with 

very little resistance. Forcing the drive into 

the slot will cause the drive damage or 

permanent damage to the Disk Array. 

3. 

Once the drive is all the way into the 

driver slot, close the door all the way until 

the drive door latches securely. This will 

engage power and data connection with the 

hard drive. The LED light for the drive slot 

should light if the Disk Array already is 

powered on. You may lock the drive door 

with the key.

4. 

To remove the hard drive from the 

Disk Array, simply follow the steps 2-3 in 

reverse. 

Door lock

Individual Drive

       Bay Door

Drive power and 

    LED activity

for each Drive bay

Insert Hard Drives

with top facing

right