Справочник Пользователя для AMD LX 900@1.5W
432
AMD Geode™ LX Processors Data Book
Video Processor Register Descriptions
33234H
6.8.3.15 Video Downscaler Control (VDC)
VXS Bit Descriptions
Bit
Name
Description
63:32
RSVD (RO)
Reserved (Read Only). Reads back as 0.
31:20
X_ACC_INIT
X Accumulator Initial Value. Load this value before each video line. Works with hori-
zontal scaling, in case a sub-pixel offset is required prior to displaying video. Pad 4 LSBs
with 0 when loading.
zontal scaling, in case a sub-pixel offset is required prior to displaying video. Pad 4 LSBs
with 0 when loading.
19:0
VID_X_SCL
Video X Scale Factor. Bits [19:16] represent the integer part of horizontal scale factor of
the video window according to the following formula:
the video window according to the following formula:
X_SCL_INT = 1/Xs
Where:
Xs = Arbitrary horizontal scaling factor.
Bits [5:0] represent the fractional part of horizontal scale factor of the video window
according to the following formula:
according to the following formula:
VID_X_SCL = FFFFh * 1/Xs
Note:
If no scaling is intended, set to 10000h. Will be greater than 1000h when down-
scaling. Will be less than 10000h when upscaling.
scaling. Will be less than 10000h when upscaling.
VP Memory Offset 078h
Type
Type
R/W
Reset Value
00000000_00000000h
VDC Register Map
63 62 61 60 59 58 57 56 55 54 53 52 51 50 49 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 32
RSVD
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
9
8
7
6
5
4
3
2
1
0
RSVD
DT
S
RSVD
DFS
DC
F
VDC Bit Descriptions
Bit
Name
Description
63:7
RSVD (RO)
Reserved (Read Only). Reads back as 0.
6
DTS
Downscale Type Select.
0: Type A (downscale formula is 1/m + 1, m pixels are dropped, one pixel is kept).
1: Type B (downscale formula is m/m + 1, m pixels are kept, one pixel is dropped).
1: Type B (downscale formula is m/m + 1, m pixels are kept, one pixel is dropped).
5
RSVD (RO)
Reserved (Read Only). Reads back as 0.
4:1
DFS
Downscale Factor Select. Determines the downscale factor to be programmed into
these bits, where m is used to derive the desired downscale factor depending on bit 6
(DTS). Only values up to 7 are valid.
these bits, where m is used to derive the desired downscale factor depending on bit 6
(DTS). Only values up to 7 are valid.
0
DCF
Downscaler and Filtering. Enables/disables downscaler and filtering logic.
0: Disable.
1: Enable.
1: Enable.