Справочник Пользователя для Oregon Scientific RMR602A
EN
6
CHANGE SETTINGS
1.
Press and hold MODE for 2 seconds to enter setting
mode.
mode.
2.
Press UP or DOWN to change settings.
3.
Press MODE to confirm.
TABLE STAND OR WALL MOUNT
Use the stand on the back of the product, or mount it on
a wall with a nail.
a wall with a nail.
GETTING STARTED
BATTERIES
Batteries are not supplied with this product. You will need
to purchase 2 x UM-4 (AAA) 1.5V alkaline batteries for
the main unit, and 2 x UM-3 (AA) 1.5V alkaline batteries
for the remote sensor.
to purchase 2 x UM-4 (AAA) 1.5V alkaline batteries for
the main unit, and 2 x UM-3 (AA) 1.5V alkaline batteries
for the remote sensor.
Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
Do not use rechargeable batteries.
NOTE
shows when batteries are low.
REMOTE SENSOR
This product is shipped with a remote sensor that collects
temperature readings. Only one sensor can be used with
this product.
temperature readings. Only one sensor can be used with
this product.
UNIT
LOCATION
Main
Indoor Temperature Area
Remote
Outdoor Temperature Area.
RMR602A lab test R2
1/17/04, 4:49 PM
6