Справочник Пользователя для Oregon Scientific BAR623PA
10
EN
To force a manual search for atomic clock signals, press
and hold for 2 seconds. If no signal is found, check
the batteries.
and hold for 2 seconds. If no signal is found, check
the batteries.
TURN ATOMIC CLOCK SIGNAL ON / OFF
Perform this step if you cannot receive atomic clock
signals. Press and hold for 2 seconds. Then, manually
set the clock following the “Set Clock” instructions.
signals. Press and hold for 2 seconds. Then, manually
set the clock following the “Set Clock” instructions.
The signal icon indicates that the clock feature is
ON. No icon means that it is OFF.
ON. No icon means that it is OFF.
Once complete, the reception icon will stop blinking. The
icon is shown in the Clock Area.
icon is shown in the Clock Area.
STRONG SIGNAL
WEAK SIGNAL
NO SIGNAL
SEARCH FOR SENSOR
To search for the sensor, press and hold SEARCH (on
the main unit) for 2 seconds.
the main unit) for 2 seconds.
NOTE If the sensor is still not found, check the batteries,
obstructions, and remote unit location.
obstructions, and remote unit location.
NOTE Signals from household devices such as
doorbells, electronic garage doors, and home security
systems may cause temporary reception failure. This is
normal and does not affect general product performance.
The reception will resume once the interference ends.
doorbells, electronic garage doors, and home security
systems may cause temporary reception failure. This is
normal and does not affect general product performance.
The reception will resume once the interference ends.
CLOCK
The clock automatically synchronizes the current time
and date when it is brought within range of the WWVB-
60 atomic clock signal generated from Fort Collins,
Colorado. For more information, please visit: http://www.
boulder.nist.gov/timefreq/stations/radioclocks.htm
and date when it is brought within range of the WWVB-
60 atomic clock signal generated from Fort Collins,
Colorado. For more information, please visit: http://www.
boulder.nist.gov/timefreq/stations/radioclocks.htm
NOTE The signals are collected by the main unit when
it is within 932 miles (1500 km) of a signal.
it is within 932 miles (1500 km) of a signal.
Initial reception takes 2-10 minutes, and is initiated when
you first set up the unit, and whenever you press RESET.
you first set up the unit, and whenever you press RESET.