Справочник Пользователя для Oregon Scientific MSR939A
EN
12
shows on the clock display when batteries are low
or when there are no batteries installed and only the
adaptor is connected.
adaptor is connected.
The LED indicator on the motion sensor and vibration
alarm will flash in red when the batteries are low.
alarm will flash in red when the batteries are low.
AC ADAPTOR
The clock / projector and the motion sensor use 6V and
4.5V AC / DC adaptors respectively. (Adaptor for the
motion sensor is not included.)
4.5V AC / DC adaptors respectively. (Adaptor for the
motion sensor is not included.)
The clock AC adaptor socket is found on the bottom of
the clock. The jack can be inserted into the socket as
shown below:
the clock. The jack can be inserted into the socket as
shown below:
The remote sensor jack can be inserted into the socket
as shown below:
as shown below:
The motion sensor has a Power ON / OFF
switch to help conserve energy. Use the AC adaptor
when using the motion sensor for long periods of time.
The batteries are a good power source for back-up use.
when using the motion sensor for long periods of time.
The batteries are a good power source for back-up use.
ABOUT ATOMIC CLOCK RECEPTION
This clock can automatically synchronize the date and
time with
time with
an official time-keeping organization in
Boulder, Colorado
. The unit can pick up
an atomic
clock signal
when it is within
932 miles (1500km)
of
these locations. For more information on the Atomic
Clock, please visit www.nist.gov
Clock, please visit www.nist.gov
NOTE
RMR939PA English R5
9/21/04, 2:40 PM
12