Справочник Пользователя для Acu-Rite CNC 3500i
192
7 Programming: Canned Cycles, sub-programs
7.
2 Canned Cy
cles
Side Finish
Use Side Finish to remove side stock left by a previously
programmed pocket cycle.
programmed pocket cycle.
Side Finish must be programmed immediately after a compatible
pocket cycle that has left side stock. All side stock is removed in one
pass if no DepthCut is specified. Multiple finish passes are possible
using SideStock.
pocket cycle that has left side stock. All side stock is removed in one
pass if no DepthCut is specified. Multiple finish passes are possible
using SideStock.
Islands definitions apply to this cycle, and will be avoided, and sides
finished if active.
finished if active.
Islands need to be re-defined after the pocket cycle, before the Side
Finish call.
Finish call.
G-code format: G134
Field
Code
Description
ZDepth
Z
Absolute pocket depth. Default is last
roughing cycle used.
roughing cycle used.
StartHgt
H
Z absolute starting height (0.1” or 2 mm
above surface). Default is last roughing
cycle used.
above surface). Default is last roughing
cycle used.
RampFeed
I
The feedrate at which the tool will "ramp"
into the pocket in all three axes. Default is
last programmed feedrate.
into the pocket in all three axes. Default is
last programmed feedrate.
FinFeed
K
Feedrate used during finish passes. Default
is last programmed feedrate.
is last programmed feedrate.
DepthCut
B
The depth of each cut per pass. Default is
entire depth removed in one pass.
entire depth removed in one pass.
SideStock
M
Amount of stock left on sides for an
additional finish pass.
additional finish pass.
FinishDir
Q
Select Cw or Ccw.