Справочник Пользователя для Primera Technology 510212

Section 4: Ribbon and Print Media

Digital Label Press 3 User’s Manual

3. Place the supply end of the ribbon into the supply end of the Ribbon Cartridge

as indicated. Make certain that the ribbon is fed from underneath the supply

end of the ribbon roll, up and over the top of the take-up end of the ribbon roll.

4. Once the ribbon is installed into the Ribbon Cartridge, it can then be placed

into the printer. See Part D of this section for instructions on inserting a loaded

Ribbon Cartridge into the printer.

D. PLACING THE RIBBON CARTRIDGE INTO THE PRINTER

1. Press the Cover Release Button. Allow the cover to swing up and open.
2. With the cover open, place the Ribbon Cartridge into the printer. Be certain that

the supply end of the Ribbon Cartridge is oriented towards the rear of the

printer.

3. Close the cover. When you start to print, the notches on the Ribbon Drive Hub

will automatically engage the take-up end of the ribbon.

NOTE: When the ribbon is installed properly, the black sensing plug in the supply end of the ribbon

roll should be located in the back, left-hand corner of Press's interior. This sensing plug tells

Press which type of ribbon is installed and MUST be present in order for Press to function.

Take-Up End

Supply End

Impressa3.qxd 10/22/01 9:29 PM Page 21