Справочник Пользователя для Barco 26-0503000-00

Using the Video Switching Tab

The “clear” procedure enables you to clear (or “blank”) a route.  

„

On the Video Switching Tab, use the following steps to clear a route:  

1.  In the Outputs Section, click the output channel that you want to clear.  The 

button lights yellow along with its currently assigned input.  

2.  In the Inputs Section, click the currently assigned input button.  In the video 

column, the label “--” appears in a red squared, indicating that a “blank” route is 
pending.

3.  Click TAKE.  The selected input button turns off, indicating that the input has been 

cleared and the output channel has been blanked.    

The RGB Mute feature enables you to blank a channel’s output video while leaving the 
channel’s sync signals running to the monitor.  

„

On the Video Switching Tab, use the following steps to “mute” an output:  

1.  Verify that an active route is in place (based on a bright green square in the Video 

column) for the selected output. 

2.  In the Outputs Section, enable the check box in the RGB Mute column for the 

output that you wish to mute.  The channel is immediately muted — pressing 
TAKE is not required.

3.  Repeat from step 1 to mute another output channel.

Please note the following important points:

To clear an RGB Mute route, simply disable the check box.

You can perform a “multi-clear” in the same manner as you 
performed a multi-take.