Справочник Пользователя для Motorola MT2070
2 - 102 MT2070/MT2090 User Guide
To load or remove profiles:
1.
Navigate to a check box next to the profile.
2.
Press the orange key on the keypad and press the Space key to select/clear the check box.
3.
Use the Tab key to navigate to Select All (select all profiles) or Deselect All (deselect all profiles) and press
ENT.
ENT.
Configure USB
This utility is used to configure the USB protocol which runs when a USB cable is attached to the MT20X0 or
STB2078 cradle. An asterisk (*) appears next to the selection indicates the current setting.
STB2078 cradle. An asterisk (*) appears next to the selection indicates the current setting.
To access USB Config, start at the Home screen, scroll to Config....
Figure 2-138
Configure USB Screen
NOTE
The Serial Port profile is always active and cannot be removed.
NOTE
ActiveSync, SNAPI, SNAPI with imaging apply only to the MT20X0. If selected and paired to the cradle,
HID keyboard is used.
HID keyboard is used.
Retail CDC only applies to the STB2078 cradle. If selected and a USB cable is directly connected to the
MT20X0, ActiveSync is installed.
MT20X0, ActiveSync is installed.
When configured in ActiveSync, decode data is not transmitted after a scan and an error beep (four
beeps) sound.
beeps) sound.
Table 2-29
Configure USB - Option Descriptions
USB Configuration
Description
ActiveSync
Configures the device to use ActiveSync on device only.
Note: If connecting ActiveSync via USB, it is recommended you
use an ESD dongle with the USB cable. (ESD part numbers
KT-8830-03R -3 piece kit, or KT-8830-10R - 10 piece kit.)
use an ESD dongle with the USB cable. (ESD part numbers
KT-8830-03R -3 piece kit, or KT-8830-10R - 10 piece kit.)
Keyboard
Configures the device to use HID Keyboard Emulation on the
device and cradle.
device and cradle.
SNAPI
Configures the device to use the SNAPI protocol on device only.