Справочник Пользователя для Acer 5230
Chapter 4
111
Index of Error Messages
Error Code List
Error Codes
Error Messages
006
Equipment Configuration Error
Causes:
1. CPU BIOS Update Code Mismatch
2. IDE Primary Channel Master Drive Error
(THe causes will be shown before “Equipment
Configuration Error”)
Causes:
1. CPU BIOS Update Code Mismatch
2. IDE Primary Channel Master Drive Error
(THe causes will be shown before “Equipment
Configuration Error”)
010
Memory Error at xxxx:xxxx:xxxxh (R:xxxxh, W:xxxxh)
070
Real Time Clock Error
071
CMOS Battery Bad
072
CMOS Checksum Error
110
System disabled.
Incorrect password is specified.
Incorrect password is specified.
<No error code>
Battery critical LOW
In this situation BIOS will issue 4 short beeps then shut
down system, no message will show.
In this situation BIOS will issue 4 short beeps then shut
down system, no message will show.
<No error code>
Thermal critical High
In this situation BIOS will shut down system, not show
message.
In this situation BIOS will shut down system, not show
message.
Error Message List
Error Messages
FRU/Action in Sequence
Failure Fixed Disk
Reconnect hard disk drive connector.
“Load Default Settings” in BIOS Setup Utility.
Hard disk drive
System board
“Load Default Settings” in BIOS Setup Utility.
Hard disk drive
System board
Stuck Key
Keyboard error
Keyboard Controller Failed
Keyboard locked - Unlock key switch
Unlock external keyboard
Monitor type does not match CMOS - Run
Setup
Setup
Run “Load Default Settings” in BIOS Setup Utility.
Shadow RAM Failed at offset: nnnn
BIOS ROM
System board
System board
System RAM Failed at offset: nnnn
DIMM
System board
System board
Extended RAM Failed at offset: nnnn
DIMM
System board
System board
System battery is dead - Replace and run
Setup
Setup
Replace RTC battery and Run BIOS Setup Utility to
reconfigure system time, then reboot system.
reconfigure system time, then reboot system.
System CMOS checksum bad - Default
configuration used
configuration used
RTC battery
Run BIOS Setup Utility to reconfigure system time, then
reboot system.
Run BIOS Setup Utility to reconfigure system time, then
reboot system.