Справочник Пользователя для Technika SP112iPH

CONNECTING POWER
Before connecting the power, check that the mains voltage 
on  the  rating  plate  of  the  AC  adaptor  is  the  same  as  the 
voltage in your area.

Plug the DC cord from the AC adaptor into the DC In jack 

•

on the back of the unit. 
Plug the AC adaptor  into the wall socket and switch the 

•

mains  power on. 

The unit is now ready for use.
NOTE:- The AC adaptor may become warm during operation 
- this is normal.

SETTING THE CLOCK
When  the  unit  is  switched  on  for  the  first  time,  the  clock 
display will read 0:00.
To set the clock -

Press the 

•

TIME button.

Press the

•

}

 or SET-/

{

 button to set the hours 

digits to the correct time.
Press the 

•

/,

 button when the hours setting is correct.

Press  the

•

}

  or  SET-/

{

  button  to  set  the 

minutes to the correct time.
Press  the 

•

/,

  button  when  the  minutes  setting  is 

complete.

The time is now set.
If backup batteries have been fitted, the correct time will be 
maintained when the AC power is disconnected.

Locate  the  backup  battery  compartment,  underneath 

•

the base of the unit.
Slide off the battery cover.

•

Fit 2 x AAA batteries, observing polarity. When replacing 

•

the batteries, use only the same AAA type specified.

Replace the battery cover.

•
The backup batteries will ensure that the clock retains the 
current time and alarm settings in the event of a power cut.

NOTE:- The  backup  batteries  are  only  for  backup  purposes 
and will not power the unit.

DISPOSAL OF BATTERIES
Dispose  of  used  batteries  with  regard  to  the  recycling 
regulations  in  your  area.  Do  NOT  short  circuit  batteries  or 
throw them into water, the general rubbish or in a fire.
Weak  batteries  can  leak  and  damage  the  docking  station. 
Replace them in good time!