Справочник Пользователя для Cisco Systems NSS2000 Series
Setting up the Hardware
Step 1 — Install the Disk Drives
NSS2000 Getting Started Guide
4
2
Step 1 — Install the Disk Drives
After you remove the NSS from the packaging, you are ready to set up the
hardware. If your NSS already has disk drives installed, skip this step.
hardware. If your NSS already has disk drives installed, skip this step.
To install the disk drives into the NSS:
STEP 1
Remove a disk tray from the front of the NSS chassis by pushing in the tab on the
latch at the front of the tray then open the latch. (There is no recommended order
of which tray to remove first.)
latch at the front of the tray then open the latch. (There is no recommended order
of which tray to remove first.)
STEP 2
Position the disk drive into a disk tray.
STEP 3
Using a Phillips screwdriver, either screw in two screws on each side of the disk
tray to the disk drive or screw in the four screws on the bottom of the disk tray to
the disk drive.
tray to the disk drive or screw in the four screws on the bottom of the disk tray to
the disk drive.
a
b
Po
w
e
r
LAN
SYS
AC
T
1
ERR 1
AC
T
2
ERR 2
NSS2000
2 Ba
y Gigabit Netw
o
rk Stora
g
e System
Linksys b
y
Cisco
270983
270957
OR
270982
270958