Справочник Пользователя для Pelco C2907M-D
24
C2907M-D (4/05)
CONNECTING DATA TERMINALS
The bidirectional data interface ports can be used as control ports for equipment connected to the NET350 (for example, a dome camera with
motorized lens).
motorized lens).
•
The COM1: RS232/422/485 port supports RS-232, RS-422, and RS-485 transmission protocols.
•
The COM2: RS232 port supports RS-232 transmission protocols.
PIN ASSIGNMENTS
NOTE:
Transmission of transparent data is only possible when a video connection has been established.
CONNECTING AUDIO EQUIPMENT
The NET350 provides an audio channel through the Audio I/O jack. The audio signals are transmitted bidirectionally and simultaneously with the
video signals. This allows control of a loudspeaker or door intercom system as required. Bidirectional, full duplex audio applies to box-to-box
connections only.
video signals. This allows control of a loudspeaker or door intercom system as required. Bidirectional, full duplex audio applies to box-to-box
connections only.
1. Connect a preamplified microphone (monaural line) to the Audio I/O jack on the transmitter.
2. Connect a loudspeaker to the Audio I/O jack on the receiver.
Figure 18.
Connecting Audio Equipment
Table A.
Pin Assignments
COM1 COM2
Pin
RS-232
RS-422/485
RS-232
1
DCD (data carrier detect)
–
–
2
RX (receive data)
RX+ (receive data plus)
RX (receive data)
3
TX (transmit data)
TX- (transmit data minus)
TX (transmit data)
4
DTR (data terminal ready)
–
–
5
GND (ground)
GND (ground)
GND (ground)
6
DSR (data set ready)
–
–
7
RTS (ready to send)
TX+ (transmit data plus)
–
8
CTS (clear to send)
RX- (receiver data minus)
–
9
–
–
–
WARNING:
Pay attention to documentation relating to the installation and operation of the equipment being controlled.
1 2 3 4 5
6 7 8 9
GND
In
Out