Справочник Пользователя для Pelco C2907M-D

C2907M-D (4/05)

59

•

Presets:  To program a preset from the Matrix browser page: set the image using the arrow keys, click SET, enter a preset number, and 
then click PRST. To activate a preset, enter the preset number (1-66) and then click PRST. (You must click the CLR button before activating 
another preset.)

•

Patterns:  To program a pattern from the Matrix browser page: click SET, click PATT, run your pattern using the arrow keys, and then click 
PATT again when you are finished. (The CM6700 does not support programming of a pattern from the browser.) To run a pattern, click 
PATT. To halt, click a pan and tilt button, call a preset, or click STOP. (Clicking STOP will not halt a pattern on the CM6700 and CM6800.)

NOTE:  For the CM6700 only, click the ACK button to close the message “Send Pattern End Command to Exit” when it appears.

•

Programming menus:  To access the programming menus, click 9, 5, SET, and then PRST.

•

Macros:  To start a macro, enter 1 or 2 and click MAC. To stop a macro, select a camera or click a pan and tilt button.

•

Auxiliaries:  To turn on an auxiliary, enter the auxiliary number and then click AUX ON. To turn off, enter the auxiliary number and then 
click AUX OFF. 

Figure 44.  Genex Control Page (Live Video Page Shown) 

The Genex pages contain the following across the top of the page: 

•

Live video indicators (live video page only) 

•

Main and Spot monitor selection radio buttons

•

A LIVE/VCR button to toggle main monitor display between live input and playback from a VCR 

•

A Sequence button to activate a group camera sequence 

•

A View button to show in Live mode the multiplexed output from the VCR and in VCR mode to show the multiplexed input from the VCR 

•

A zoom button 

•

A picture-in-picture button 

•

Buttons for 4-, 9-, and 16-screen display