Справочник Пользователя для Vanguard Managed Solutions 6500 PLUS
Installation
2-45
Installing Nodes in Modulus Enclosures
Installing and Connecting a TRIM Card
Introduction
This section describes how to install a TRIM card in a 6500
PLUS
node.
Caution
6500
PLUS
cards and their components are sensitive to static discharge, which can
damage components. Use proper handling and grounding precautions, including the
use of an anti-static grounding strap, whenever you handle a card.
use of an anti-static grounding strap, whenever you handle a card.
Steps for Installing
a TRIM Card
a TRIM Card
To install a TRIM card, perform the following steps:
1) Attach the TRIM card if it is not already attached when it arrives from the
factory.
2) Install the processor card into the modulus nest.
3) Connect the LAN cables.
Note
In multiple-CPU configurations, only the processor card supporting the TRIM
card needs to be LAN-compatible.
card needs to be LAN-compatible.
Attaching a TRIM
Card
Card
Depending on the product code you have ordered, your TRIM card may arrive
already attached to the processor card. If this is the case, skip to the next section,
“Installing and Connecting a TRIM Card.” Otherwise, follow these steps:
already attached to the processor card. If this is the case, skip to the next section,
“Installing and Connecting a TRIM Card.” Otherwise, follow these steps:
Step
Action
1
Follow the Modulus space considerations described in previous sections.
2
Attach the TRIM rear filler panel to the enclosure.
• If you are installing the TRIM card in a Modulus 8/18 enclosure,
use a Phillips-head screwdriver to attach the TRIM rear filler
panel to the backplane with the four screws provided
(Figure 2-8).
panel to the backplane with the four screws provided
(Figure 2-8).
• If you are installing the TRIM card in a Modulus 9/21 enclosure,
use a flat-head screwdriver to attach the captive screws on the top
and bottom of the rear filler panel to the backplane (Figure 2-10).
Attach a standard Modulus rear filler panels as needed.
and bottom of the rear filler panel to the backplane (Figure 2-10).
Attach a standard Modulus rear filler panels as needed.
3
Attach the header pins to the TRIM card. Insert the header pins in the
socket so that the four pins without ferrite beads face the top of the
processor card (Figure 2-13).
socket so that the four pins without ferrite beads face the top of the
processor card (Figure 2-13).
The pins should seat firmly into the socket; do not bend them.
4
Turn the 6500
PLUS
processor card so that its solder side faces upward.
Insert the header pins into the socket on the processor card, being careful
not to bend the pins (Figure 2-13).
not to bend the pins (Figure 2-13).
Be sure to support both the TRIM and processor cards while pressing
them together to avoid bending and thereby possibly damaging the
processor card.
them together to avoid bending and thereby possibly damaging the
processor card.
5
On the component side of the processor card, screw the four fastener
screws into the standoffs on the TRIM card (Figure 2-13).
screws into the standoffs on the TRIM card (Figure 2-13).