Справочник Пользователя для National Instruments NI WLS/ENET-9163

Complete the following steps to prepare the NI WLS/ENET-9000 Series 
device for use:

1.

Before connecting the hardware, install NI-DAQmx software, 
LabVIEW SignalExpress, and the NI-DAQ Device Documentation 
Browser. Refer to the DAQ Getting Started Guide for more 
information about software installation. 

The NI-DAQmx software is included on the CD shipped with your kit and is 

available for download at 

ni.com/support

. After you install it, the NI-DAQ Device 

Documentation Browser is available from Start»Programs»National Instruments»
NI-DAQ»Browse Device Documentation. The DAQ Getting Started Guide is available 
after installation from Start»Programs»National Instruments»NI-DAQ»DAQ Getting 
Started Guide.

2.

If you are not using any mounting accessories or stacking the devices, 
attach the provided rubber standoffs to the bottom of the 
NI WLS/ENET-9000 Series device, as described in the 

3.

Make sure the NI WLS/ENET-9000 Series device power is 
disconnected.

4.

Attach a ring lug, as shown in Figure 6, to a 14 AWG (1.6 mm) wire. 
Connect the ring lug to the ground terminal on the bottom of the device 
using the ground screw. Attach the other end of the wire to the system 
ground.