Справочник Пользователя для National Instruments Ultiboard

© National Instruments Corporation

Mounting holes and connectors are placed from the database. Refer to the 

 section for more information. 

You can also place holes directly onto the workspace, without using the 
database, as described below. 

1.

Select Place»Hole. The Through Hole Pin Properties dialog box 
appears. 

2.

Select the desired Shape for the whole. The Hole Preview changes 
accordingly. 

If you select Custom

 the Get a Part from the Database dialog box 

displays, where you must navigate to the desired part in the database. 

3.

Enter the desired Units, Length, Radius and Width for the hole. 

4.

Optionally, enable Plated in the Drill Option area if you wish the hole 
to be plated. 

5.

Click OK. The dialog closes and the hole is placed on the cursor. 

6.

Move the cursor to the desired location and click to place it on the 
workspace. 

7.

You can continue clicking to place more instances of the same hole, or 
right-click to cancel placement. 

Ultiboard allows you to place various shapes and graphics on your design, 
and to move them once they have been placed. Depending on your active 
layer, the set of available shapes and graphics for placement, and what they 
represent, may differ. 

Choose the following commands to place shapes and graphics: 

Left-click two points to draw a line between them. 
Continue clicking to draw another segment of the same 
line, or right-click to stop.  

Left-click two points that define the ellipse’s focuses, then 
move the pointer to define the ellipse’s size.