Справочник Пользователя для National Instruments Ultiboard

This feature lets you swap pins and/or gates after moving part(s) on the 
workspace. 

For this feature to function, you must allow pin/gate swapping in the 

Spreadsheet View, and in the Design Rules

tab of the PCB properties dialog box. 

Complete the following steps to swap pins and gates automatically after a 
part move: 

1.

Move desired parts on the workspace. 

2.

Select Design»Automatic Pin Gate Swap. Pins and gates are 
swapped to achieve the most efficient routing of nets possible. 

 

The above figure shows U1 before the automatic pin/gate swap. Note 
the position of the ratsnests. 

The figure below shows U1 after the automatic pin/gate swap. Note the 
new position of the ratsnests.