Справочник Пользователя для National Instruments Ultiboard

4.

Optionally, in the Next Label area:

•

Increment—Enable to increase a number that you placed at the 
end of the text with each successive placement of that text. You 
must also enter a value in Step Size. For example, if you enable 
this checkbox and enter “1” in Step Size, and the Value you 
entered was “Resistor1”, the first placement of the text will say 
“Resistor1”, the second will say “Resistor2”, the third will say 
“Resistor3”, and so on. 

•

Decrement—Similar to the Increment setting, except that the 
number will decrease by the Step Size with each successive 
placement. (The number will not go below 0). 

5.

Click OK. The Text dialog box disappears; the cursor now has your 
text on it. 

6.

Move the cursor where you want the text placed, and click to drop the 
text. 

7.

Right-click to cancel the Place»Graphics»Text command. 

Complete the following steps to edit text: 

1.

Double-click the text. The Copper Attribute Properties dialog box 
opens. 

2.

Click on the Attribute tab. 

3.

Edit the text. 

4.

Click OK. The Copper Attribute Properties dialog box disappears 
and your changes are applied to the text in the design. 

You can capture an area of the screen and then manipulate the image as you 
would any other screen capture contained in the system clipboard. 

Complete the following steps to copy a section of your screen to the 
clipboard: 

1.

Select Tools»Capture Screen Area. A selection frame appears on 
your workspace.  

2.

Optionally, to move the frame to a different location: 

•

Move your cursor to the border of the frame. A crosshair is added 
to the cursor, indicating that the selection frame can be moved to 
a different location. 

•

Drag the selection frame to the desired location.