Справочник Пользователя для National Instruments Ultiboard

 

To close the 3D view, right-click on the 3D view in the Projects tab and 
choose Close Window from the context menu. 

If you loaded a file from Ultiboard 2001, before you can use the 3D view you must 

use Tools»Update Shapes. The 3D appearance of individual parts is controlled by the 3D 
properties of those parts. Refer to the 

 section of 

Chapter 4, 

, for more information. 

When you choose Tools»View 3D, the view appears so that you are 
looking at a three dimensional rendition of the top of the board on an angle. 
You can manipulate this view to show you all points on the board, top and 
bottom, at any angle you choose. 

You manipulate the 3D view with the mouse pointer, which represents your 
viewing position and the light source that illuminates the part. You can click 
and drag the mouse to rotate the board, and you can change the angle at 
which it displays, allowing you to flip it over to see the bottom. The view 
rotates around the center of the board. When you let go of the mouse button, 
the board stays in its most recent view. 

Complete the following steps to manipulate the 3D view: 

1.

Select Tools»View 3D Position. 

2.

Click and hold the mouse button down on the board in the 3D view.