Справочник Пользователя для National Instruments Ultiboard

Use the Part Groups tab to work with part groups as described in the table 
below. 

If enabled, allows like-pins to be swapped during the 
routing process. You can choose either No (not 
enabled), Yes or Use Group Settings. Refer to the 

 section of Chapter 3, 

, for more information. 

If enabled, allows like-gates, to be swapped during the 
routing process. You can choose Internal Gates 
Only, which will swap gates within the same IC; No 
Swapping; Advanced Swapping, which will swap 
gates between ICs (both devices must be set to 
Advanced Swapping); or Use Group Settings. Refer 
to the 

 section of 

, for more information. 

The group in which the part is placed. You can select 
No Group or an existing group from the drop-down 
list. Parts groups are created in the Group Editor. 
Refer to the 

 section of 

, for more information. 

This is the group in which the part is contained. Refer 
to the 

 section of 

, for more information. 

This is the minimum spacing allowed between the 
parts in the group and any trace. You can enter a value 
here, or use the Group Editor. Refer to the 

 of Chapter 3, 

, section for more information. 

This is the minimum spacing allowed between parts in 
the group. You can enter a value here, or use the 
Group Editor. Refer to the 

 of Chapter 3, 

, section for 

more information.