Справочник Пользователя для National Instruments Ultiboard

© National Instruments Corporation

•

Pin “[Pin number]” from Part “[refdes]”(value) in Net “[Net 
name]” is missing from shape “[shape name]”— A pin belonging to 
the specified part was given in the netlist but does not exist in the shape 
that was given for the part.

•

Unused Pin [Pin name] is {close to, connected to} {Unused Pin, 
Copper}—The given pin that was not assigned to a net is close to or 
connected to another unused pin or copper, for example, a trace, 
powerplane, or copper area. 

•

Design Rule Error: Net [Net1 name] { connected to} { Net2 name, 
Unused pin, copper, Board outline }—The given net was connected 
to another net, an unused pin, copper or the board outline.

•

Design Rule Error: Net Gnd Close to Net [Net name] 
[RefID:PIN#-netname]—The given net was too close to another net.

You can set up whether the design rule check runs in “real time”, and define 
the actions to be taken when Ultiboard encounters a design rule error, such 
as cancelling the current action, asking for confirmation, or overruling the 
error. Refer to the 

 section of Chapter 1, 

, for 

more information. 

The Edit Groups dialog box is where you create and edit net groups, part 
groups, bus groups and differential pairs. 

Refer to the following sections for more information: 

•

•

•

•

•

Use the Add group dialog box to create groups in the Edit Groups dialog 
box. Refer to the following subjects for more information: 

•

•

•

•