Справочник Пользователя для National Instruments NI PCI-6111

© National Instruments Corporation

This chapter explains how to install and configure the NI PCI-6110/6111.

It is important to install the software before installing the NI PCI-6110/6111 to 

ensure that the device is properly detected.

1.

Install the ADE, such as LabVIEW or Measurement Studio, according 
to the instructions on the CD and the release notes.

2.

Install NI-DAQ according to the instructions on the CD and in the 
DAQ Quick Start Guide included with the device.

The following are general installation instructions. Consult the computer or 
chassis user manual or technical reference manual for specific instructions 
and warnings about installing new devices.

You can install the NI PCI-6110/6111 in any available expansion slot in the 
computer. However, to achieve best noise performance, leave as much room 
as possible between the NI PCI-6110/6111 and other devices and hardware.

1.

Power off and unplug the computer. 

2.

Remove the top cover or access port to the I/O channel.

3.

Remove the expansion slot cover on the back panel of the computer.

4.

Ground yourself using a grounding strap or by holding a grounded 
object. Follow the ESD protection precautions described in the 

 section of Chapter 1, 

5.

Insert the NI PCI-6110/6111 into a PCI system slot. Gently rock the 
device to ease it into place. It may be a tight fit, but do not force the 
device into place.