Справочник Пользователя для National Instruments PXI-8170 Series

© National Instruments Corporation

This chapter contains basic instructions for setting up the PXI-8170 
embedded computer.

You can use this chapter as a guide to configure and operate your PXI 
system quickly using the PXI-8170 Series. This chapter assumes that you 
intend to perform a basic configuration as follows:

•

You have one PXI mainframe in which you will be using the PXI-8170.

•

You will use the default settings.

The PXI-8170 Series default settings are listed below. If you want to use 
a different configuration, refer to Appendix A, 

, for information about changing the settings.

Electrostatic discharge can damage several components on your PXI-8170 

module. To avoid such damage in handling the module, touch the antistatic plastic package 
to a metal part of your PXI mainframe before removing the module from the package.

This section summarizes the hardware default settings for the PXI-8170 
Series for easy reference. The module is set at the factory for the most 
commonly used configuration.

Tables 3-1, 3-2, and 3-3 list the factory-default settings (in bold type) and 
options for the onboard jumpers and switches. Two jumpers and three 
switches are on the CPU board, and three jumpers are on the I/O board.

Table 3-1.  Jumpers on CPU Board

Clear CMOS

J4: 3-5 short

Clear CMOS

Onboard Video Enable

J4: 4-6 short

Onboard video disabled