Справочник Пользователя для National Instruments TPC-2512
Chapter 2
System Setup
2-2
ni.com
If one of the following situations arises, have service personnel check the
equipment:
equipment:
•
The power cord or plug is damaged.
•
Liquid has penetrated into the equipment.
•
The equipment has been exposed to moisture.
•
The equipment does not work well, or you cannot get it to work
according to the user manual.
according to the user manual.
•
The equipment has been dropped and damaged.
•
The equipment has obvious signs of breakage.
Do not leave this equipment in an environment where the storage
temperature may go below –20 °C (–4 °F) or above 60 °C (140 °F). Doing
so could damage the equipment. The equipment should be in a controlled
environment.
temperature may go below –20 °C (–4 °F) or above 60 °C (140 °F). Doing
so could damage the equipment. The equipment should be in a controlled
environment.
Caution
There is a danger of explosion if the battery is incorrectly replaced. Replace the
battery only with the same or equivalent type recommended by the manufacturer. Discard
used batteries according to the manufacturer’s instructions.
used batteries according to the manufacturer’s instructions.
The sound pressure level at the operator’s position according to
IEC 704-1:1982 is no more than 70 dB (A).
IEC 704-1:1982 is no more than 70 dB (A).
Caution
The protection this equipment provides may be impaired if it is used in a manner
not described in this manual.
Setup
Follow these steps to set up the TPC-2012/TPC-2512:
1.
Unpack the TPC-2012/TPC-2512. Be sure your kit includes the
following items:
following items:
•
The TPC-2012/TPC-2512 HMI
•
Eight panel mounting clamps
•
Eight panel mounting screws
•
One 3-pin power connector
•
One HMI Resource CD
•
One CompactFlash to IDE adapter card
If any items are missing or damaged, contact National Instruments.