Справочник Пользователя для National Instruments Measure Data Acquisition
© National Instruments Corporation
B-1
Measure Data Acquisition User Manual
Error Codes
This appendix describes the errors that can occur while using the
Measure DAQ Add-In.
Measure DAQ Add-In.
Table B-1. Data Acquisition Error Codes
Error
Code
Error
Description
-10001
syntaxErr
An error was detected in the input string;
the arrangement or ordering of the
characters in the string was not
consistent with the expected ordering.
the arrangement or ordering of the
characters in the string was not
consistent with the expected ordering.
-10002
semanticsErr
An error was detected in the input string;
the syntax of the string was correct, but
certain values specified in the string were
inconsistent with other values specified
in the string.
the syntax of the string was correct, but
certain values specified in the string were
inconsistent with other values specified
in the string.
-10003
invalidValueErr
The value of a numeric parameter is
invalid.
invalid.
-10004
valueConflictErr
The value of a numeric parameter is
inconsistent with another one, and
therefore the combination is invalid.
inconsistent with another one, and
therefore the combination is invalid.
-10005
DSPbadDeviceErr
The device is invalid.
-10006
badLineErr
The line is invalid.
-10007
badChanErr
Possible reasons for this error are as
follows.
follows.
•
A channel is out-of-range for the
device type or input configuration.
device type or input configuration.
•
The combination of channels is not
allowed.
allowed.
•
The scan order must be reversed
(0 last).
(0 last).
-10008
badGroupErr
The group is invalid.
-10009
badCounterErr
The counter is invalid.