Справочник Пользователя для Nortel Networks Option 11C Mini
Chapter 18 — Connecting the trunks
Page 277 of 332
Option 11C Mini
Planning and Installation Guide
6
Enter the TN in Option 11 format (CCUU).
The response
“MODEL?”
prompts you to select a model number for the trunk.
“MODEL?”
prompts you to select a model number for the trunk.
7
Enter a trunk model number for the specified TN, and route and
press the pound key (#).
press the pound key (#).
The character display shows:
“OK”
After a delay of approximately four seconds, you hear special dial tone.
The sequence is repeated when the following prompt appears on the
character display.
The sequence is repeated when the following prompt appears on the
character display.
“TN?”
8
Hang up or repeat the sequence.
The sequence ends when the last unit in the card is used and the
program is complete, or when you hang up the telephone receiver.
program is complete, or when you hang up the telephone receiver.
Note: The model used for the first trunk activated in the sequence will
be the default for all subsequent trunks. This is the case until you hang
up or you manually enter a new trunk model number.
be the default for all subsequent trunks. This is the case until you hang
up or you manually enter a new trunk model number.
—————————— End of Procedure ——————————