Справочник Пользователя для Nortel Networks 4050

82 Chapter 3 Managing the network access devices

320818-A

 

The VLANs are configured on the network access devices. You specify the Red 
VLAN for each network access device when you add the switch (see 

). After adding the switch, you 

must identify the Yellow and Green VLANs to the Nortel SNAS 4050.

You can perform the VLAN mapping in two ways:

•

for all switches in a domain (by using the 

 

command)

•

switch by switch (by using the 

 

command)

Nortel recommends mapping the VLANs by domain. In this way, if you later add 
switches which use the same VLAN IDs, their VLAN mappings will 
automatically be picked up.

If you map the VLANs by domain, you can modify the mapping for a particular 
network access device by using the switch-level 

 command. Switch-level 

settings override domain settings.

To manage the VLAN mappings for all the network access devices in the Nortel 
SNAS 4050 domain, first disable all the switches in the domain, then use the 
following command:

To manage the VLAN mappings for a specific network access device, first disable 
the switch in the domain, then use the following command:

dis

Disables the switch for Nortel SNA operation.

delete

Removes the switch from the Nortel SNAS 4050 
domain configuration.

/cfg/domain #/switch <switch ID>

followed by: