Справочник Пользователя для Nortel Networks 4050

Chapter 3 Managing the network access devices 91

Nortel Secure Network Access Switch 4050 User Guide

 

To restart communication between the Nortel SNAS 4050 and a network access 
device, use the following command:

Enter 

 to apply the change immediately.

The Nortel SNAS 4050 starts communicating with the network access device as 
soon as you enable the switch on the Nortel SNAS 4050.

You cannot configure the VLAN mappings for a network access device in the 
Nortel SNAS 4050 domain if the switch is enabled. When you add a network 
access device to the domain, it is disabled by default. Do not enable the network 
access device until you have completed the configuration. For information about 
enabling and disabling the network access device, see 

.

To add a network access device, use the following steps:

Select the Secure Access Domain > domain > Switches > Switches tab.

Note: Remember to enable the network access device after completing 
the configuration, or it will not be active.