Справочник Пользователя для Gateway ALR 8200
4 Gateway ALR 8200 User’s Guide
Setting up the server
Refer to Figure 1 and the following procedures when connecting optional
peripherals to your system.
peripherals to your system.
Figure 1: Connecting Peripherals
1.
Connect the keyboard and mouse to their respective ports using the
pictures on the server’s rear cover as a guide.
pictures on the server’s rear cover as a guide.
2.
Connect the monitor video cable to the video port. The location of the
port may vary depending on whether you use the integrated video or a
video card.
port may vary depending on whether you use the integrated video or a
video card.
3.
Connect the monitor power cable to an AC outlet or, preferably, a
surge control outlet station.
surge control outlet station.
4.
Verify that the voltage selector switch on the power supply is set for
the proper voltage (115V or 230V). If the system includes two
hot-swap modules, each module has a voltage selector switch.
the proper voltage (115V or 230V). If the system includes two
hot-swap modules, each module has a voltage selector switch.
Important!
Shielded cables are
required by the FCC.
required by the FCC.
4078tl.book Page 4 Tuesday, December 22, 1998 2:19 PM