Справочник Пользователя для Dialogic TX4000 PCI SS7
4
4
Configuring the TX 4000 board
Using the configuration utility
After you install the TX 4000 board and the NaturalAccess Signaling Software, you
must assign a CP number to each TX 4000 board. Verify that you have completed
the steps described in the installation summary on page 16 before you proceed to
the steps described in the installation summary on page 16 before you proceed to
assigning a CP number on page 22.
To assign a CP number, you will use the txcpcfg utility. Depending on the operating
environment, the txcpcfg utility is located in one of the following directories:
To assign a CP number, you will use the txcpcfg utility. Depending on the operating
environment, the txcpcfg utility is located in one of the following directories:
Operating system
Directory
Windows
Program Files\Dialogic\tx\bin\
UNIX
/opt/dialogic/tx/bin/
txcpcfg enables you to perform the following types of changes to the configuration:
• Assign a CP number
• Add a board
• Change a CP number
• Move a board
• Remove a board
• Save configuration changes
• Add a board
• Change a CP number
• Move a board
• Remove a board
• Save configuration changes
For more information about txcpcfg, refer to the Dialogic® TX Series SS7 Boards TX
Utilities Manual.
Dialogic Corporation
21