Справочник Пользователя для Quantum DLT VS80
Chapter 4: DLT VS80 Use
4-2
May 2004
001596-01 Rev A07
4.1.1 Indicator Activity During Power-On Self-Test (POST)
Every time you power on your tape drive, it conducts a power-on self-test (POST). This test ensures
that your tape drive is working properly and is ready to use. While POST is in progress, watch the front
panel LEDs.
that your tape drive is working properly and is ready to use. While POST is in progress, watch the front
panel LEDs.
1.
The LEDs illuminate all at once and then turn off.
2.
The Ready (green) LED blinks during initialization and remains illuminated after POST.
3.
The tape drive emits a buzzing sound as it calibrates the read/write head’s position. POST is
complete only after the buzzing sound stops.
complete only after the buzzing sound stops.
POST takes sever seconds to complete, after which the tape drive is ready to use.
4.1.2 Indicator Activity During Tape Drive Operation
When your tape drive is in use, a variety of indicator LEDs can blink or be illuminated.
describes the circumstances under which one or more indicators are illuminated or blinking
immediately after POST.
immediately after POST.
Table 4-1.
Tape Drive Status and Indicator Activity
Tape Drive Status
Indicator Activity
Power to the tape drive
The Ready LED is on
No power to the tape drive
The Ready LED is off
The tape drive detected an unrecoverable hard
error condition
error condition
The Drive Error LED is on
The tape drive detected a recoverable
read/write error
read/write error
The Clean/Media LED blinks